The Ultimate SCSI2SD For Samplers Site - the Final Word

Article - Translator Can't See My SD Card

2019-08-02 (Last Update: Fri, 02 Aug 2019) Garth Hjelte 0 General

 

I have a SCSI2SD mounted in my ESI-4000 - all I need to do is copy the contents of the SD card to backup my banks in the PC if this is possible - but Translator isn't even seeing the SCSI2SD drives (7) which I have formatted and saved banks to.

IF USING YOUR COMPUTER'S CARD READER TO ACCESS THE SD CARD
The most important thing is to match the start/length numbers in the SCSI2SD Utility with the Format Preferences-SCSI2SD Partition Map in Translator. The easiest way of doing this is to read the contents of the board using the Utility, Save As a XML file, and read the XML file in the Format Preferences-SCSI2SD Partition Map dialog. Then refresh Translator when the SD card is in your computer's card reader, they should show under Proprietary Drives.

IF USING YOUR SCSI2SD AS YOUR COMPUTER'S CARD READER (v6.x only)
In Format Preferences-SCSI2SD Partition Map, uncheck Enable SCSI2SD Multiple Device Detection. This is necessary because your SCSI2SD v6.x board presents itself as (up to) 7 devices and it is not necessary for Translator to read "into" the SD card. Then referesh Translator; all the ID's (if formatted for Emu) should show.

Comments are disabled.